Operating And Regulating The Machine - Solo Music Gear 531 Instructions D'emploi

-Picture 7-

OPERATING AND REGULATING THE MACHINE

Before beginning to mow grease the moving bar with oil. Then start up the engine following the directions.
"
Engaging the transmission to the wheels and the cutting bar by means of the clutch lever must be carried out with the motor
at a middle r.p.m. and by slowly releasing the lever.
"
When starting to mow, position the accelerator lever at 3/4 or at "MAX" to ensure adequate power.
"
When mowing along a wall or the edge of a sidewalk, be careful to keep a safety distance so that the blade does not suffer
impact. If not, the cutting bar may undergo damage.
"
If the belts are slipping, operate on the adjustment devices (Ref "E" Picture 6) which are on the clutch levers. Leave a gap
of about 5 mm before the clutch engage. To adjust the wheel releasing cable, operate on the adjustment device "F" (Picture
6)
"
It is possible to adjust the handle vertically, by acting on the knobs that fix it to the handlebar support: two different positions
are available (Picture 8 Ref A).
"
It's possible to have another little vertical adjustment of the handle, by rotating the handlebar support, after having loosened
the screws that fix it to the transmission box. Then screw tight again. (Ref. "B" Picture 5)
"
To regulate the motor, read the manual on the motor under "REGULATIONS".
10
-Picture 8-
-Picture 9-