Rechargeable) Batteries; Electrical Installation; Installation - Sygonix 2443659 Mode D'emploi

c) (Rechargeable) batteries
• Correct polarity must be observed while inserting the (rechargeable) battery.
• The (rechargeable) batteries should be removed from the device if it is not used for a long period of time
to avoid damage through leaking. Leaking or damaged (rechargeable) batteries might cause acid burns
when in contact with skin, therefore use suitable protective gloves to handle corrupted (rechargeable)
batteries.
• (Rechargeable) batteries must be kept out of reach of children. Do not leave (rechargeable) batteries
lying around, as there is risk, that children or pets swallow them.
• All (rechargeable) batteries should be replaced at the same time. Mixing old and new (rechargeable)
batteries in the device can lead to (rechargeable) battery leakage and device damage.
• (Rechargeable) batteries must not be dismantled, short-circuited or thrown into fire. Never recharge
non-rechargeable batteries. There is a risk of explosion!
d) Electrical installation
WARNING! Safety hazard!
The product should only be installed by people with relevant electrical knowledge and experience! *)
If it is not installed properly, you risk:
• your own life
• the life of user of the electrical device
• severe damage to property, e.g., by fire
• personal liability for personal injury and material damage
Always consult an electrician!
*) Technical knowledge required to perform the installation:
For the installation, the following specialist knowledge is required in particular:
• The "Five safety rules": Disconnect from the mains; protect against accidental switch-on; ensure there is
no voltage; earth and short-circuit; cover or protect adjacent live parts
• Use of suitable tools, measuring devices and personal protective equipment, where necessary
• Analysis of measurement results
• Use of electrical installation materials to meet the requirements for disconnection
• IP protection ratings
• Installation of electrical installation materials
• Type of power supply (TN system, IT system, TT system) and the corresponding connection criteria
(classic earthing, protective earthing, necessary additional measures etc.)
If you are not a professional, do not do it yourself, have it performed by a specialist.
e) Installation
• The attachment to the ceiling should have sufficient strength to withstand 4x the weight of the ceiling fan.
• Consult a professional if in doubt about how to correctly install this product.
23