Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5
Installation
Installing the DHW temperature sensor
▶ Take the tank temperature sensor [3] from the scope of delivery of
the control panel (accessories).
▶ Feed the temperature sensor with the compensating spring [2] all
the way into the sensor well [1].
The compensating spring [2] ensures contact between the sensor well
and sensor surfaces, and a reliable temperature reading.
Always ensure that the full length of the sensor surface is
in contact with the sensor well.
1
2
3
Fig. 10 Installing the DHW temperature sensor
[1]
Sensor Well
[2]
Compensating spring
[3]
Temperature sensor
▶ Route the sensor lead to the boiler or control panel and ensure the
cable is not strained. The piping may not touch any hot parts of the
boiler.
▶ When sensors are used without a compensating spring, fill the cavity
in the sensor well with a sufficient amount of thermal grease.
12
Installing the aquastat
▶ Remove cover from the aquastat. To do so, undo the screw on the
top.
▶ If necessary, remove any unnecessary attachments. Screw the
holder [3] onto the Aquastat [2] using two sheet metal screws [1].
Fig. 11 Screw the holder onto the Aquastat
[1]
Self-tapping screws C-ST 4.2x13 mm
[2]
Aquastat
[3]
Holder
▶ Feed the temperature sensor [4] with the compensating spring [5]
into the sensor well [3].
▶ Attach Aquastat [2] to tank by means of 2 self-tapping sheet metal
screws [1].
▶ Replace the cover of the aquastat [2].
6 720 801 773-08.1ITL
Fig. 12 Installing the aquastat
[1]
Self-tapping screws C-ST 4.2x13 mm
[2]
Aquastat
[3]
Sensor Well
[4]
Temperature sensor
[5]
Compensating spring
2
1
2
1
S32/5 – 6 720 819 302 (2017/11)
3
6 720 648 100-08.1ITL
3
4
5
6 720 648 100-09.1ITL
Publicité
Chapitres
Table des Matières
