Technical Data - Lux Tools A-FMR-20 Set Notice Originale

charged. Batteries must always be protected against
short circuits by covering the poles with adhesive
tape.
All end users are responsible for deleting any per-
sonal data stored on waste devices prior to their dis-
posal.
Disposal of the packaging
The packaging consists of cardboard and
correspondingly marked plastics that can
be recycled.
– Make these materials available for
recycling.

Technical data

Article number
Rated voltage
• maximum
• nominal
Idling speed
Protection class
Protection rating
Sound power level (L
WA
Sound pressure level (L
Vibration**
Battery charger
Rated voltage
Capacity
Charge voltage
Charge current
Protection class
Battery pack
Battery pack type
Rated voltage
• maximum
• nominal
Capacity
Charging time
*) The specified values are emission values and do not necessarily
represent safe workplace values. Although there is a correlation
between emission and immission levels, this cannot be used to
infer whether additional safety measures are necessary or not.
Factors which affect the current immission levels at the work-
place, include the type of room, other sources of noise, e. g. the
number of machines operating and other processes taking place
in the vicinity. Permitted workplace values can differ from coun-
try to country. This information is designed to help the user to
better assess the dangers and risks. Determination of noise
emission values in accordance with EN 62841-1.
**) The specified vibration emission value was measured in accord-
ance with a normed test procedure and can be used in order to
compare one tool with another. The specified vibration emission
value can also be used for an introductory evaluation of the
exposure. The vibration emission value may fluctuate from the
specified value during actual use of the power tool. These fluc-
tuations will depend on the way in which the power tool is used.
Try to keep vibrations to a minimum. One method of reducing
the vibration load is, for example, limiting the length of time you
work with the tool. All parts of the operating cycle must be taken
into account for this purpose (for example, also including times
in which the power tool is switched off and times in which it is
switched on, but is running without load). Determination of vibra-
tion emission values in accordance with EN 62841-1 &
EN 62841-2-10.
196045
20 V
18 V
−1
0–620 min
III
IP20
)* 90 dB(A)
(K = 3 dB(A))
)* 79 dB(A)
PA
(K = 3 dB(A))
4,76 m/s²
(K = 1,5 m/s²)
230 V~, 50 Hz
70 W
20,9 V
2,4 A
II
Li-Ion
20 V
18 V
4 Ah
120 min
Accessories
You can find more information about suitable batter-
ies and spare parts of the 1 Power Systems here:
see QR Code
GB
27