Inventum VVW5520 Mode D'emploi page 36

CLEANING THE FILTERS
Check once a week if there is any residue on the filters. Remove the filters and clean them thoroughly under the water tap.
The filter system consist of three components:
• sieve (A)
• filter - fine (B)
• filter - coarse (C)
Open
C
B
• Do not use the dishwasher when there are no filters in place.
• Incorrect fitting of one the filters will result in the dishwasher no longer delivering maximum performance.
• Make sure the filters are clean. This ensures proper functioning of the dishwasher.
CLEANING THE SPRAY ARM
Check the nozzles of the spray arm regularly for waste. Waste can block the nozzles and bearing in the spray arm. Remove
the clogging in the spray arm and clean them with warm water.
• Remove the spray arm by pulling it upwards.
• Clean the spray arm with warm water.
• Make sure the spray arm is perfectly locked when refitting the spray arm.
CLEANING THE DRAIN PUMP
Large food residues or foreign objects which were not captured by the filters may block the waste water pump. The rinsing
water will then be above the filter.
Warning Risk of cuts! When cleaning the waste water pump, ensure that you do not injure yourself on pieces of
broken glass or pointed implements.
• First always disconnect the appliance from the power supply.
• Take out the basket.
• Remove the filters.
• Scoop out the water, use a sponge or cloth if required.
• Check the area and remove any foreign objects.
• Install the filters.
36
• English
1. To remove the filters, turn the filter (B) anti-clockwise
2. Pull it (B and C) upwards.
A
C
3. Pull the coarse filter (C) from the fine filter (B) and clean both parts with
warm water using a dishwashing brush.
4. Take the sieve (A) out of the dishwasher and clean it with warm water and if
B
needed a dishwashing brush. Place the sieve back in the dishwasher.
5. Place the coarse filter in the fine filter with the markings allined. Re-fit the
A
filters in the sieve and turn it clockwise to fixe it.
C
B
A