Install Side Panel(S); Install Base Grille - Dacor EF36LNBSS Instructions D'installation

Install Side Panel(s)

If the built-in area depth is 25" (63.5 cm) or more, the side panels
can be installed inside the side trim or attached to the outside of
the side trim.
IMPORTANT: Dacor is not responsible for customer installed
molding or decorative panels that need to be removed or replaced
to service the refrigerator.
1. For the inside side trim piece, slide the front edge of the
routed side panel into the trim piece.
2. Nail the rear edge of the panel to the support board.
A
A. Support board (mounted to back wall)
B. Cab side trim

Install Base Grille

There are two pieces to the base grille to allow for a custom fit:
the base grille itself and the skirt. The skirt can be added to the
base grille in order to extend it all the way to the floor.
1. To see if the skirt is needed, place the base grille into position.
Do not attach the base grille to the refrigerator. Measure the
distance between the bottom of the base grille and the floor.
The gap must be a minimum of ½" (1.27 cm) in order to add
the skirt.
NOTE: If the gap measures less than ½" (1.27 cm), skip steps
3 and 4 of the instructions, and install the base grille only.
2. Remove the protective film from the base grille.
Installation Instructions
B
3. Snap the skirt onto the base grille.
4. Trim the skirt by scoring the proper "V" groove with a utility
knife. Break the skirt at the score line.
A. "V" groove
5. Using the two screws, attach the base grille assembly to the
refrigerator as shown.
NOTE: Secure the right screw in place first.
Screws (2)
A
B
A. Base grille
B. Skirt
19