Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Custom Side Panels - Model EF36
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an inset, flush or recessed inset panel installation for
model EF36.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type
of installation you are planning.
NOTES:
The dimensions shown are actual product dimensions and
ƒ
may not reflect the needed installation dimensions.
The side panel should be a minimum of ½" (1.27 cm) thick to
ƒ
avoid warping.
If the opening depth is 25" (63.5 cm) or more, you may want to
ƒ
install a support board on rear wall.
Refrigerator
"
¹⁄
24
8
(61.3 cm)
"
¹¹⁄
23
16
(60.3 cm)
"
½
23
(59.7 cm)
Side Trim
(4.7 mm)
¹³⁄
32
12
Installation Requirements
"
¼
(6.35 mm)
"
¹¹⁄
64
(4.5 mm)
"
³⁄
16
⁄
"
7
32
(5.5 mm)
⁄
5
"
" (10 mm)
8
(15.7 mm)
Inset Installation Dimensions
1.
Measure the distance from point A (as shown) to the back wall.
Add
7
⁄
" (5.6 mm) to this measurement to allow the side panel
32
to fit into the trim.
2.
If the panel is more than ¼" (6.35 mm) thick, route the front
edge to allow the side panel to fit into the trim.
Back
Wall
A
Flush Installation Dimensions
1.
Measure the distance from point A (as shown) to the back wall.
2.
Attach the support board with a screw or adhesive that is
compatible with aluminum and wood.
Back
Wall
A
Recessed Inset Installation Dimensions
1.
Measure the distance from point A (as shown) to the back wall.
2.
Route the front edge of the support board or attach a ¼" (6.35
mm) board to hold the panel in the cabinet side trim.
Back
Wall
A
Publicité
Chapitres
Table des Matières
