Level And Align Refrigerator - Dacor EF36LNBSS Instructions D'installation

Réfrigérateur encastré de 36”
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Level and Align Refrigerator

WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT: All four leveling legs must contact the floor to
support and stabilize the full weight of refrigerator. Rollers are for
moving refrigerator and not for permanent support.
After moving the refrigerator to its final location:
1.
Use a
5
" socket driver to turn the leveling bolts clockwise to
16
extend the legs to the floor as shown. The rollers should be off
the floor.
A B
A. Rear leveling bolt
B. Front leveling bolt
2.
Adjust the leveling legs to level and align the refrigerator from
left to right and front to back so that the refrigerator is level
and aligned with the cabinets. The cabinet surface must be
plumb for the ideal fit of the refrigerator side trim.
16
Installation Instructions
A
B
3.
Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.54 cm) of the
top soffit.
NOTE: If an anti-tip board has been used, adjust the leveling
legs until the top of the refrigerator is within ¼" (6.35 mm) of
the bottom of the anti-tip board as shown. Do not crush the
compressor cover.
2" (5 cm)
D
A. Center board
¼
" (6.35 mm) max. above refrigerator
B. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
IMPORTANT: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with the door
alignment or top grille fit. To avoid damage to the cabinet or
leveling legs, do not apply more than 50 inch-pounds (5.65
Nm) of torque to the leveling bolts. The leveling legs can be
extended to a maximum of 1¼" (3.18 cm) below the rollers.
4.
For IF series models, additional adjustments may be needed
after the custom panels are installed.
A
B
C

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Ef36rnbssIf36lnbolIf36rnbol

Table des Matières