Adjust Doors - Dacor EF36LNBSS Instructions D'installation

Custom Panel Installation - IF36
Series Models (Continued)
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up, then pull straight out. Place the top grille
panel-side down on a soft working surface.
B
A. Top grille
B. Cabinet side trim
3. Remove one end cap by loosening the nuts and sliding the
end cap off.
C. Bottom rail
D. Nuts
4. Slide the custom panel into the top grille channel and reattach
the end cap.
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
18
Installation Instructions
A B
E. End cap
F. Top rail
G. Custom panel

Adjust Doors

Door Swing Adjustment
1. Check that the refrigerator door can open freely. If the door
opens too wide, remove the door stop screw or screws
(depending on your model) from the bottom hinge with a Torx
T15 screwdriver.
2. Hold the door open to a position that is less than 90°.
3. Replace the door stop screw or screws in the bottom hinge
and tighten.
A. Door stop screw
A
B
B. 130° position
C. 110° position (IF series refrigerators)
D. 90° position
IMPORTANT: Do not place the door stop screw in the 130°
position on IF Series models. See "Handle and Door Clearances."
Door-to-Door or Door-to-Refrigerator Trim
Adjustment
1. Loosen, but do not remove, the four Torx 27 flat-head
mounting screws and the two ¼" hex head mounting screws.
2. Adjust the top hinge of either door to align it with the other
door or the refrigerator trim.
3. Tighten the four Torx 27 flat-head mounting screws to a torque
of approximately 100 inch-pounds (11.3 Nm) and tighten the
two ¼" hex head mounting screws.
B
A. Torx 27 flat-head mounting screws
¹⁄
B. " hex-head mounting screws
4
C D
A