Custom Panels And Handles - Dacor EF36LNBSS Instructions D'installation

Custom Panels and Handles - IF36 Series Models (Continued)
Custom Panels Construction Information
See page 9 for overall dimensions.
NOTE: Spacer panels must be at least 1" (2.54 cm) from the top,
bottom, and side edges of the backer panel.
3-Piece Grille Overlay Panel Configuration
T o p V e i w
A. Offset dimension
" (6.25 mm) Backer panel
B. /
1
4
" (3.18 mm) Spacer panel
C. /
1
8
" (1.92 cm) Decorative
D. /
3
4
overlay panel
3-Piece Door Overlay Panel Configuration
1"
(2.54 cm)
A
A. Offset dimension
B. / " (6.25 mm) Backer panel
1
4
C. / " (3.18 mm) Spacer panel
1
8
D. / " (1.92 cm) Decorative overlay panel
3
4
1-Piece Overlay Panel Configuration
In some cases, your cabinet manufacturer may choose to work
with one panel routed for the different dimensions. Follow these
panel dimensions and placement instructions to be sure that the
custom overlay panels will fit properly.
10
Installation Requirements
S d i e V e i w
D
C
B
1"
(2.54 cm)
A
B C D
Custom Handles
Dacor recommends handles with larger D-style pulls. If using
screws with thick heads, they must be countersunk into the panel
before installing the handles.
Any handle designed for use with an appliance should produce
satisfactory results. Mounting screw length varies with the total
thickness of the panels.
IMPORTANT: Dacor does not advise the use of single pull knobs.
Trim frame
A
surrounding door
A. Countersunk screw
B. Handle
C. Door panel assembly
20" Typ.
(50.8 cm)
36" Max.
(91.4 cm)
B
Door
C