Publicité
Les langues disponibles
Les langues disponibles
GENERAL USAGE INSTRUCTIONS
This Jack is designed only for lifting a part of the total vehicle. Secure the vehicle after lifting directly with a
suitable supports stands. Do not move or dolly the vehicle while it is on the jack.
FIRST TIME OPERATION
1.
Before using the floor jack, check for loss of oil, damage or missing accessories.
2.
Connect the pump lever (1) with the pump arm (8) and open the drain valve by turning it
counter-clockwise.
3.
To ensure the oil distributes itself completely, carry out approx. 6 full pumps with the pump lever
handle (1).
4.
Close the drain valve by turning the pump lever (1) completely clockwise.
5.
The vehicle jack is now ready for use.
LIFTING THE VEHICLE
1.
Before using the floor jack, check for loss of oil, damage or missing accessories
2.
Locate your vehicle on an even, firm surface and secure the vehicle against rolling as specified by the
vehicle manufacturer.
3.
To ensure safe lifting, position the jack at a 90° angle to the vehicle and under the appropriate jacking
point (see the manufacturer's instructions).
4.
Insert the pump lever (1) into the pump arm (8) and fix it with the screw (19). Close the drain valve by
rotating clockwise until the limit stop is reached.
5.
Before lifting the load, check that the drain valve is properly closed
6.
Pump with the pumping lever (1) or the quick lift pedal (2) until the saddle (6) is in contact with the
lifting point at the bottom of the vehicle. Attention: The quick-lift pedal is not suitable for lifting load, it
is only for quick lifting of the saddle to the height of the vehicle lifting point.
7.
Check again that the jack is seated correctly.
8.
Continue pumping the pump lever until the vehicle has been lifted to the desired height.
9.
Caution: Observe the vehicle and the jack during the lifting operation.
10. Put the pumping lever (1) out of the pumping arm (2). (Risk of accident!)
11. Secure the load with suitable jack stands before commencing work on or under the vehicle.
Caution: Working on or under the vehicle without first appropriately securing the raised load is
prohibited! (Risk of accident!)
12. After you have finished working on the vehicle, lift the vehicle again and remove the jack stands.
Than open the drain valve by carefully twisting the jack handle in small increments in a counter-
clockwise direction until the vehicle begins to move downwards.
13. Once the vehicle is firmly on the ground, the drain valve can be opened again (approx, one half turn)
in order to return the lifting arm (5) all the way to the bottom in the starting position.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicité
