Publicité
Les langues disponibles
Les langues disponibles
place the foot strap.
Illustrations 16-17:
Fastening and unfastening the child's feet: To hold the child's feet
in position, fix the foot strap on the inside of the adjusting pin (fig.
17, A) and then fasten it to the outside (fig. 17,B). To release the
foot strap follow the procedure in reverse. Always make sure your
child's feet are well fastened to the footrests. The foot rest is long
for easy adjustment.
DANGER: always hook the foot straps onto both sides of the fasten-
ing pins to prevent them from coming into contact with the wheel
spokes.
Illustrations 18-19:
Setting belt height: the belt can be extracted to adjust its height by
inserting the buckle behind the backrest through the opening each
time (fig.19). Choose the upper or lower openings to fix the belts
based on the child's height. Setting belt length: modify belt length
by sliding the buckles. The belts must be fastened firmly without
them being too tight for the child.
Fastening the belts: Fasten the belt clasp. Check that the belt clasp
clicks shut properly, and then pull the belt.
Illustration 20:
To unfasten the belt, simultaneously press the two buttons (front
and rear) found on the clasp.
Maintenance
1)
Clean the seat, the padding and the belts with warm water and a
mild detergent. Do not use solvents or abrasive or corrosive de-
tergents. Leave the padding to dry in the open air. Do not iron.
2)
Seat repairs and replacement of damaged components must
only be carried out by authorized personnel.
Technical specifications
Product
Dimensions
Weight
Compliance and manufacturer information
Manufactured in compliance with European Standard EN14344.
Manufacturer:
OKBABY srl, Via del Lavoro 26, 24060 Telgate (BG) Italy.
+39 035 830004 - okbaby@okbaby.it - www.okbaby.it
10
Child bike seat OKBABY mod. Baby Shield
with carrier rack fastening system
43x57x73 CM (LxDxH)
4Kg
Baby Shield Rear child's seat
Publicité
