Publicité
START-UP PROCEDURE
PRE-START PREPARATION
Before starting the pressure washer, check for loose or missing
parts and for any damage which may have occurred during shipment.
Handle Installation
Remove the handle by pressing the handle release buttons. Turn
the handle around and insert back into the carrier, pushing down until
the handle release buttons lock into place (see figure 1).
Figure 1
START-UP PROCEDURE
1.
Make sure water supply is connected and turned on.
2.
Release gun safety if locked.
3.
To allow air to escape from the hose, squeeze trigger on
the gun until there is a steady stream of water coming
from the nozzle.
4.
Remove any dirt or foreign matter from the gun outlet and
the male connector of the wand.
5.
Insert the nozzle wand into the gun wand and tighten the
fitting securely.
STARTING THE ENGINE
1.
Check oil and fuel level.
2.
Set the engine switch to the "ON" position.
3.
Push the primer as necessary.
4.
Squeeze trigger on pressure washer to release pressure
while pulling on the engine starter rope with a fast steady
pull. Pressure may otherwise build up making starting the
unit difficult.
OPERATING CONNECTIONS
HIGH PRESSURE HOSE
Attach the high pressure hose to the fitting located on the front
side of the side panel (outlet connection). Only high pressure (2700
PSI) pressure washer hoses should be used.
WATER CONNECTION
Before connecting the inlet hose to the unit, run water through
the garden hose (not supplied) to flush out any foreign matter. The
inlet hose will be connected to the fitting (Figure 1) .
English
HIGH PRESSURE/LOW PRESSURE
The high pressure nozzle position is intended for clean-
ing. When high pressure is required, grasp collar and slide the
collar and nozzle toward the gun.
NOTE: Make sure the nozzle cover is pulled to the
extreme rear position to lock the nozzle in the high pres-
sure position.
High Pressure
Low Pressure
When low pressure is required, grasp and slide the nozzle
cover away from the gun.
ADJUSTABLE SPRAY NOZZLE
The adjustable spray nozzle can adjust spray from fan to
pencil point in both the high and low pressure positions. The
spray is adjusted by turning the nozzle cover.
FanSpray
To increase angle to a fan spray,
turn counterclockwise.
Pin Point Spray
To decrease angle to a pencil point
spray, turn clockwise.
CAUTION: The pencil point spray adjustment
is very aggressive. We recommend that for most
cleaning applications, a twenty degree (20°)
spray angle be used to avoid damage to the
surface being sprayed.
5
Publicité
