Mestra KOALA Mode D'emploi page 13

6. Press "Start/Stop" Key to indicate we
want a pause after this step. You will see
"Mixing" light mode flickering quickly.
7. Press "Programme" Key. "P5-2" will
appear on the display indicating we are
in Programme 5 step 2.
8. Press "Selection" Key till "Vacuum" Mode
light lights.
9. Select 10 seconds with "Up/Down" Keys.
10. Press "Programme" Key for approx. 3
seconds."P5-3"
display indicating you are in Programme
5 step
11. Press selection key until "Vacuum +
Mixing" light lights.
12. Select 1 minute with "Up/Down" Keys.
13. Press "Programme" Key for approx. 3
seconds."End" will appear on the display
and the machine would go back to stand-
by mode. The programme is now stored
in memory.
MAINTENANCE AND CLEANING
To ensure an optimum reliability and long
life of the machine, we recommend:
Carefully clean the mixing bowls after
•
using them. Avoid dirt accumulation and
possible blade shaft seizing. Make sure
to clean the joint and fitting of the bowl to
get optimum sealing.
Cleaning of external body of the machine
•
should be made with a soapy water
dampened cloth. Do not use solvents or
any other flammable product.
Change the filtering element periodically
•
by turning anticlockwise a quarter turn
the filter glass on the backside of the
machine. Change the filtering element
and place the glass on its place again.
In case there were a current breaking
•
while the cycle is running, the bowl will
remain at the nozzle because of vacuum.
Under these conditions it may happen
that the mixture sets. To avoid this
inconvenience, you may see that there is
a drain-valve at the bottom of the glass.
Pressing the
vacuum in the vacuum circuit pressurizes
and the bowls gets free. Carry out this
operation only in case of emergency.
It is recommended to change mixer and
•
bowl rubber joints periodically. Vacuum
in vacuum circuit will be optimised.
will appear on
drain-valve shaft
We recommend you to use always
•
Mestra original spare parts in Mixer
servicing.
PRECAUTIONS
♦ Before connecting the machine, make
sure it is a 230 V, 50/60 Hz electric point
with earth.
♦ Never place the bowl when the Mixer is
running.
the
♦ Do not let children or not qualified people
handle the machine.
♦ Choose a firm, rigid and well-levelled
wall to place the Mixer. Make sure
rawlplugs are well fixed in the wall.
♦ After a cycle has finished wait till the
display shows "End" to remove the bowl.
♦ While cleaning operations disconnect the
machine from electricity supply.
♦ Use the drain-valve to pressurize the
vacuum
emergency, (current breaking while the
cycle is running).
TECHNICAL DATA
Voltaje:
Power:
Height:
Width:
Depth:
Weight:
the
circuit just in
230 V, 50/60 Hz
250 W
250 mm
306 mm
320 mm
9 kg
English
case of
13