Perry Electric 1TPTE502B Mode D'emploi page 11

FIXING BASE TO THE WALL
A Holes for fixing the base: -
to round, rectangular flush-
mounted or to the wall box
B Passage of wires from: -
round or rectangular flush-
mounted box, corrugated tube
A
C
D
Installation to round or rectangular flush-mounted box
Surface mounting (to fix the base directly to the wall,
use special plugs not supplied).
To ensure the trhermostat is fitted correctly to the wall-mounted base,
care must be taken to ensure that the base is not distorted by screwing
the round or rectangular back box too tightly to the wall.
C Passages for wires from wall -
raceway (remove diaphragm)
D Thermostat fixing teeth -
A
C
B
D
C
Note: installation and electrical connections of
devices and appliances must be carried out by skilled
persons and in compliance with current regulations.
PROBE INSTALLATION
Insert the electric wire of the probe into a gaiter (e.g. rigid
or corrugated pliable conduit) according to the type of
installation.
Fasten the sensor capsule at the measuring point being
careful to avoid any direct contact between the
metallic parts.
Nickel- plated copper capsule
Important: the sensor and its cable must not be accessible to
the user once installation has been completed.
FIXING AND REMOVING THE
THERMOSTAT FROM THE
SURFACE-MOUNTED BASE
EN
11