Bimar HR314 Notice D'instructions page 15

Position the first intermediate column on the lower column (previously assembled
with the base and counterweight) and for locking, turn clockwise until it stops.
Place the second intermediate column on the other central column previously
fixed and for locking, rotate clockwise all the way.
Place the upper column on the intermediate column, for locking turn counter-clockwise
as far as possible and tighten correctly.
At the end of the operation, check that the support columns are firmly coupled.
Place the short side of the angle bracket on the
rear plate of the heating unit, for fixing use the
two screws supplied with wing nuts (M6 * 14mm)
and tighten properly.
Place the long side of the angle bracket on the
upper column and fix it with the two supplied
screws (M6 * 47mm) and tighten properly.
At the end of the operation, check that the
heating unit is firmly fixed to the column.
To orient the radiance of the heating unit in the most
convenient way, adjust the inclination of the metal bracket
using an allen key (not supplied).
OPERATION
The stove is equipped with a 0/I switch, select the switch
in position "I" to turn on the appliance.
To turn off the stove, press the switch in position 0.