Publicité
Les langues disponibles
Les langues disponibles
- Keep the product away from children or from their environment.
Never allow children to operate the product. Children should be supervised to ensure that they do
not play with the product.
6. Do not damage the cable
- Never move the product by dragging it by the cable.
- Keep the cable away from heat and sharp edges.
- Do not step or roll over the product or steel cable.
- During operation, do not step over the product or the steel cable.
7. Safety at work
- Use both hands when transporting the product.
- Use proper protective equipment according to the work environment.
- Keep proper footing at all times and balance.
- Important: Never pull loads greater than the maximal capacity of the hand puller.
- Do not attempt to pull stationary or fix loads.
- Do not apply any side force on the load
- Not for lifting loads and Never transport persons
8. Avoid starting the product unintentionally
-The ratchet switch should always be fully engaged.
9. Check for damaged parts
- Before using or re-using the product, carefully check for all parts, to determine if product will
operate properly and perform its intended function. Any part that is damaged should be repaired
or replaced by an authorized service center.
- Check for alignment and binding of moving parts, any broken parts or mounting fixtures, and
any other condition that may affect proper operation.
- Regularly check the steel cable for signs of tear and wear. Replace any damaged cable at an
authorized service centre.
- Unless otherwise stated in the instructions, any part that is damaged should be properly
repaired or replaced by a qualified technician.
10. Repair the tool
- When repairs are carried out, only identical replacement parts should be used to avoid
endangering the user.
- Repair the product by a qualified technician.
- Repairs should be carried out by qualified technicians, using only original spare parts; to avoid
any danger for the user.
11. Product maintenance
- Keep the product properly maintained and clean for a better and safer performance.
- Follow the instructions for lubricating and changing the accessories,
- Inspect all moving parts and mounting bolts and nuts prior to use. Tighten if necessary.
- Keep handles dry, clean and free from oil and grease.
12. Rewind the cable
To rewind the cable correctly, apply a slight load on the cable.
For this purpose, hold the cable in one hand (wearing protective gloves), and rewind the cable
with the other hand.
Do not allow the cable to slip through your hand.
13. Attention: do not overreach and stay alert
- Keep proper footing and balance at all times
- Pay attention to what you are doing and use your common sense
- Do not use the product when you are tired, while under the influence of alcohol, prescription
medicines or drugs.
14. Important
- The user and/or operator are responsible for any damages or injury caused to properties and
persons.
Page 12 of 23
Publicité
