emerio HO-107774.1 Mode D'emploi page 6

HO-107774.1
DESCRIPTION
1. Heating elements
2. Built-in handle
3. Thermostat knob
4. Indicator light
5. Base
ASSEMBLY
Do not operate the oil heater without correctly fixed base support.
⚫
To fix the rear support base, fit it tightly against the fin, until it stays in place.
⚫
To fix the front support base, fit it tightly against the bottom on the front panel.
⚫
After fixing the supports, ensure that the heater stands firmly on the floor.
⚫
USING THE APPLIANCE
Position the appliance in a safe place, freestanding with at least 90cm clearance.
Set the thermostat to the "OFF" position and insert the plug into the power supply.
⚫
Turn the thermostat control clockwise all the way round until you hear a click, this sound indicates that the
⚫
oil heater is activated, the indicator light is on. Continue turning the thermostat control clockwise to its
highest setting.
When the indicator light is on, the heater is activated. This light turns on and off repeatedly according to
⚫
the function of the thermostat. (Suitable for rooms up to 5 m
Turning the thermostat clockwise will always increase the set temperature; turning it anticlockwise will
⚫
decrease the set temperature. The thermostat will automatically turn the heater on and off to keep the
setting temperature.
NOTE:
The room must be in a good tight condition; if not, the heating results will be insufficient.
⚫
After use, turn the thermostat to the "OFF" position and unplug the appliance from the power supply.
⚫
SAFETY SYSTEM:
The appliance has a safety system which automatically switches off the unit when overheated.
⚫
If overheating occurs, remove the plug from the socket, and let it cool down for at least 30 minutes.
⚫
MAINTENANCE AND CARE
The oil heater should be cleaned regularly; wipe the dust off the surface of the fins. This improves
⚫
radiation.
Unplug the appliance from the power supply and allow the appliance to cool down completely.
⚫
2
)
- 5 -
EN