ero electronic LIMITROL LHL Mode D'emploi page 8

TC type J, K, L, N, T, E, U and PLAT.II TC type J, K, L, N, T, E, U and PLAT.II
TC type J, K, L, N, T, E, U and PLAT.II TC type J, K, L, N, T, E, U and PLAT.II TC type J, K, L, N, T, E, U and PLAT.II
15
+
_
11
15
+
_
11
Fig 6.B INPUT WIRING FOR TC TYPE J, K, L, N,
T, E, U, Plat. II.
NOTE NOTE NOTE NOTE NOTE:
1) Do not run input wires with power cables.
2) For TC wiring use proper compensating cable
preferable shielded (see "Appendix B" of the
LHI or LHL user manual).
3) when a shielded cable is used, it should be
connected to one side only.
RTD INPUT RTD INPUT
RTD INPUT RTD INPUT RTD INPUT
RTD
Shield
16 15
Shield Fig. 7 RTD INPUT WIRING
NOTE NOTE NOTE:
NOTE NOTE
1) Don't run input wires together with power
cables.
2) Pay attention to the line resistance; an high
line resistance may cause measurement
errors.
3) When shielded cable is used, it should be
grounded at one side only to avoid ground loop
currents.
4) The resistance of the 3 wires must be the
same.
GB GB GB GB GB
5
RTD
14 16 15 14