Kwazar Orion Super 3,0L Notice D'emploi page 17

During operation, the pressure in the tank will decrease. Monitor the pressure on the pressure gauge
(fig. 12/pos. 3). Restore the tank pressure by pumping.
With the adjustable nozzle (fig. 10/pos. 1) you can regulate the output stream. By tightening or loosening
the nozzle tip you can achieve various spraying degrees - from mist to continuous stream.
After finishing work you must depressurise the tank - see PREPARATION FOR WORK.
The device may be carried by the shoulder strap or by the piston rod handle, which must be locked in the cylin-
der brackets for this purpose. In both cases, the pump must be tightly screwed into the head.
STORAGE AND MAINTENANCE
Each time after work wash the sprayer thoroughly with clean water. Depressurise the tank
(fig. 1/pos. 8) by pulling the safety valve pin (fig. 7a/pos. 1). Remove the pump (fig. 1/pos. 5), pour clean
water into the tank (fig. 1/pos. 8, approx. 0.25 of the tank capacity), screw in the pump (fig. 1/pos. 5) until
sealed and pump the tank. Conduct some spraying onto the previously sprayed surfaces in order to rinse the
device's spraying system. After you finish, depressurise the tank (fig. 1/pos. 8) with the safety valve (fig. 1/pos.
6) and remove the head (fig. 1/pos. 5). Remove the remaining water from the tank.
The sprayer should be stored WITHOUT PRESSURE in the temperature between +5°C and +35°C, in a shaded
place, away from heaters and out of reach of children. It is recommended to remove the pump (fig. 1/pos. 5)
from the head (fig. 1/pos. 4).
The filter (fig. 12/pos. 1) located on the lance handle (fig. 12/pos. 2) and the adjustable nozzle (fig. 10/pos. 1)
located at the lance tip (fig. 1/pos. 1) must be cleaned periodically and before any prolonged downtime.
3
If the sprayer will not be used for a long period of time, maintenance work must be performed. Remove any
residue of the spraying agent from the sprayer, rinse the sprayer with clean water and then lubricate the seals
with silicone oil (included).
In addition, periodically lubricate the moving
parts and seals of the sprayer with silicone oil.
This applies especially to the seals marked with arrows
in the figure below.
OPERATING INSTRUCTIONS
1
2
1
2
3
Fig.12
2
Fig.13a Fig.13b
PL
EN
DE
RU
FR
1
17