Westinghouse WPX2700H Mode D'emploi page 9

UNPACKING
UNPACKING THE PRESSURE WASHER
CAUTION
Always have assistance when lifting the
pressure washer. The pressure washer
is heavy; lifting it could cause bodily
harm.
Avoid cutting on or near staples to
prevent personal injury.
The following tools are required:
• Box cutter or similar device
• 10 mm wrench
1. Carefully cut the packing tape on top of the carton.
2. Fold back top flaps to reveal the owner's manual.
Remove owner's manual and save it for reference.
3. Carefully cut two sides of the carton to remove the
pressure washer.
COMPONENTS
Verify the contents against the list below. If any parts
are missing, please locate an authorized Westinghouse
dealer at www.wpowereq.com or call 1-855-944-3571.
High-Pressure Hose (1)
Wheels (2)
Spray Gun Bracket (1) with fasteners (2)
Wheel Axle Lock Pin (2)
Wheel Axle Pin (2)
Soap Hose and soap tank (pre-installed) (1)
Spray Gun (1)
Spray Gun Lance (1)
Bottle of Oil SAE 10W30 with funnel tip (1)
Owners Manual (1)
Warranty (1)
Emissions Statement (1)
Spray nozzles (4 - WPX2700H, 5 - WPX3100H)
Nozzle Cleaning Tool (1)
NOTE: Soap and gasoline are not included
INSTALLING WHEELS
BEFORE ASSEMBLING THE PRESSURE
WASHER REVIEW THE SAFETY
SECTION STARTING ON PAGE 5.
1. Place pressure washer on a flat surface.
2. Place a piece of cardboard or other soft material to
tip the pressure washer onto, to protect the frame
paint and prevent the pressure washer from sliding.
Tip the pressure washer onto its side.
3. Insert axle pin through wheel.
4. Install the wheel with axle pin through the axle
bracket on the frame. The eye of the bolt should be
facing toward the inside of the pressure.
2
3
5. Install the hairpin cotter through the axle pin to lock
it in place.
1 - Axle Bracket
2 - Hairpin Clip
3 - Axle Pin
6. Repeat previous steps on other wheel.
Westinghouse Outdoor Power Equipment | 9
1