Dimplex Opti-myst Pro 1000 Manuel Du Propriétaire page 7

Installation
a power supply wire to the
Opti-myst Cassette when installing before
finishing wall.
!
NOTE: A 15 amp, 120 volt alternating
current (VAC) circuit is required. A dedicated
circuit is preferred but not essential in all
cases. A dedicated circuit will be required if,
after installation, the circuit breaker trips or the
fuse blows on a regular basis when the heater
is operating. Additional appliances on the
same circuit may exceed the current rating of
the circuit breaker.
Figure 1
A
!
NOTE: Use minimum 14 AWG supply
cable with two insulated copper conductors
(white and black) and one bare ground wire.
A
CDFI-
44.9"
BX1000
(114 cm)
Mounting
Flanges
B C
31.75" 14.7"
(80.5 cm) (37.3 cm)
Heater
Exhausst
C
E
B
D
D E
9.5" 4.8"
(24 cm) (12.2 cm) (39.3 cm)
G
F
F G
15.5" 16.2"
(41.2 cm) (115.2 cm)
I
H
H I
45.2" 32.3"
(82 cm)
7