Dometic TEC 29 EV Notice D'utilisation page 16

Technical description
Control elements in the control panel
The control panel is located on the generator behind the cover.
No. in
fig. 2,
Description
page 4
1 Main switch
2 TEC29 EV only: Cut-out
switch
3 TEC29 EV LPG only:
Main fuse
4 TEC29 EV LPG only:
Battery charger fuse
Control elements in the remote control
The remote control is installed in the vehicle interior.
No. in
fig. 3,
Description
page 4
1 Display
On/Off switch P
2
3 START button
4 TEC29 EV only:
Petrol gauge
5 Oil gauge
16
TEC29 EV, TEC29 EV LPG
Switches the generator to standby or no
function.
Electromechanical protection against over-
load.
Triggers if the AC voltage overloads. Fuse
needs to be replaced if it has triggered.
Triggers if the AC voltage overloads. Fuse
needs to be replaced if it has triggered.
Shows the status reports.
Switches the remote control on and off if the
main switch is at "I" or "1".
Stops the generator.
Starts the generator if the remote control is
switched on and the main switch is at "I" or
"1".
Lights up if the petrol goes into reserve.
Lights up if the oil level is too low in the
engine.
EN