cecotec TOTAL IRON 10100 PRO Manuel D'instructions page 16

ENGLISH
Storage
1. Fold the ironing board and hanger bracket to the storage position.
2. Store the cord in its corresponding compartment.
3. Store the iron and garment steamer in their corresponding compartment.
4. Move the appliance by pulling it along by the board handle.
Tip: After a long ironing session, it is advised to keep the ironing board folded out to let it dry
before you store it.
6. CLEANING AND MAINTENANCE
• Turn off, unplug the appliance from the power supply, empty the water tank and
allow it to cool down completely after each use.
• If there is any fabric adhered to the soleplate, use a damp cloth with vinegar to wipe
off the soleplate.
• Do not use abrasive scouring pads, powders or cleaners to clean the product.
7. TROUBLESHOOTING
Question Answer
Why does the iron or
The iron or garment steamer is not switched on. Press the
garment steamer remain
iron or garment steamer power-on button.
cold?
The Autocleaning process may be in progress. Wait for the
process to finish and then switch on the appliance again.
The automatic shut-off function may have been activated.
The appliance is switched off automatically when the steam
generator has not been used for 15 minutes. Press power-on
switch once to restart the appliance. It is ready for use when
the light on the iron or garment steamer turns blue.
30 TOTA L IRO N 1 0 1 0 0 PR O
Why doesn't the iron
There may not be enough water in the water tank or the
or garment steamer
water tank is not placed in the water tank compartment pro-
produce any steam?
perly. Fill the water tank and put it back into the water tank
compartment properly.
The appliance may not be hot enough to produce steam.
Heating up takes two minutes. Wait until the light on the iron
or garment steamer turns blue. Then press the steam trigger
to start steam ironing or press the steam activator to start
steaming.
You may not have pressed the steam trigger on the iron
or the steam activator on the garment steamer. Press the
steam trigger to start steam ironing or press the steam
activator to start steaming.
The automatic shut-off function may have been activated.
The appliance is switched off automatically when the steam
generator has not been used for 15 minutes. Press power-on
switch once to restart the appliance. It is ready for use when
the light on the iron or garment steamer turns blue.
Why does the appliance
It is normal to hear a pumping sound. When you hear an
produce noise?
intermittent noise, water is intermittently pumped from the
water tank into the boiler.
When you hear a long pumping noise, the Autocleaning
process is in progress. This is normal.
The noise you hear may be the sound of the fan. The applian-
ce is equipped with a fan that runs continuously during use.
This fan optimises the performance of the appliance and
cannot be switched off.
If the pumping noises do not stop, first check if the water
tank is placed in the water tank compartment properly. If
this is the case but the noises still persist, switch off the
appliance and contact the official Technical Support Service
of Cecotec.
Why do water droplets
Water collects inside the supply hose of the iron or garment
come out of the iron?
steamer and this water comes out of the iron or garment
steamer as water droplets during the first few seconds of
steaming at the start of an ironing or steaming session and
after an interruption during the session.
Are the ironing board cover
You can wash the ironing board cover in a washing machine,
and the felt underlayment
using the delicate cycle. Do not wash the felt underlay in a
washable?
washing machine. You can hand wash the underlay gently.
ENGLISH
TOTA L I RO N 1 0100 PR O 31