cecotec TOTAL IRON 10100 PRO Manuel D'instructions page 15

ENGLISH
6. a) Press the Power button.
b) Press the On/off button.
c) Select the fabric material to activate the device.
- The preheating light indicator will flash.
- After approx. 2 minutes, the preheating light
will stop flashing, indicating the device is
ready for use.
- The heating ready light indicator will flash
then.
- The iron ready light indicator will turn on red
when heating.
- The same iron ready light indicator will turn
blue indicating it is ready for use.
7. Press the steam trigger to start steam ironing.
Warning: Do not direct steam at people.
8. To iron in blowing mode on the board, press the
shift button on the top of the iron or press the blowing
button on the touch panel.
- When this function is activated, the board
cover is filled with air for a more comfortable
ironing. It is ideal for ironing the most difficult
parts of clothes.
- Tap on the blowing indicator on the panel or
press the top shift button on the iron to stop
the blowing mode.
9. To iron in suction mode on the board, press the
shift button on the top of the iron or press the suction
button on the touch panel.
-The suction mode holds the garment flat and
neat on the board, and makes perfect pleats
on trousers.
- Tap on the suction indicator on the panel or
press the top shift button on the iron to stop
the blowing mode.
28 TOTA L IRO N 1 0 1 0 0 PR O
Using the garment steamer
The garment steamer enables you to remove creases with
only a few strokes. It is easy to use, safe for all garments and a
great solution for delicate fabrics like silk.
- Switch on the garment steamer by pressing the garment
steamer power-on button on the panel.
- The on light indicator will turn on red when heating, and
then will turn blue to indicate that the garment steamer
is ready for use.
- Press the steam button to start steaming.
Autocleaning
Warning: The appliance cannot be used during the Autocleaning process, do not interrupt it.
Note: The Autocleaning process is automatically activated after 2 litres of water have been
used.
1. During the Autocleaning process, the cleaning light indicator on the panel will turn on red.
This process will last approximately 3 minutes. The device might emit some noises during
the process due to the inner process.
2. After approximately 3 minutes, rinsing water will flow into the dirty water tank.
3. Pull out the dirty water tank and empty it.
4. Slide the dirty water tank back into the appliance.
Auto-off
This appliance is equipped with an automatic shut-off function. When the steam trigger is not
used for more than 15 minutes approx., the appliance automatically shuts off and switches to
the standby mode.
ENGLISH
TOTA L I RO N 1 0100 PR O 29