cecotec TOTAL IRON 10100 PRO Manuel D'instructions page 14

ENGLISH
5. OPERATION
Control panel
Top: From left to right
1. Autocleaning indicator light
2. Iron
3. Blow
4. Suction
5. Voice (on/off)
6. Garment steamer
7. Water indicator light
Middle: From left to right
14. Preheating light indicator: it turns on while heating.
15. Heating ready light indicator: it turns on when preheating is finished.
Type of water
It is recommended to use tap water at room temperature to operate the device.
Do not use hot water, perfume, vinegar, starch, detergent, ironing additives or other chemicals.
If water quality in your area is not good because it contains too much scale, mix purified or
distilled water with some tap water.
Warning: Do not use only distilled, descaled or perfumed water.
26 TOTA L IRO N 1 0 1 0 0 PR O
Bottom: From left to right
8. Nylon
9. Silk
10. Wool
11. Cotton
12. Linen
13. On/off
Types of fabrics
Fabrics with these symbols are suitable for ironing, for example: linen, cotton, polyester, silk,
wool, viscose, rayon.
Fabrics with this symbol are not suitable for ironing.
These fabrics include synthetic fabrics such as Spandex or elastane, Spandex-mixed fabrics
and polyolefin (e.g. polypropylene), and also prints on garments.
Using the iron
1. Connect the cord to a power supply.
2. Take out the water tank, fill it with room
temperature tap water and install the water
tank back in the appliance.
3. Unfold the ironing board to horizontal position.
4. Set the ironing board to the appropriate height
with the lifting pedal.
5. Take the iron and garment steamer out of the
storage compartment.
ENGLISH
TOTA L I RO N 1 0100 PR O 27