Hayward TRX-20 Guide D'utilisation page 5

STEP 1
1. Manually clean/vacuum your pool.
2. Perform a backwash, clean your filter,
skimmer baskets and pump basket.
3. Make sure your chemical balance is
correct. If not, now is the time to correct it. If you
chemically shock the pool, wait a day or two before continuing.
4. Point all your return fittings downward.
STEP 2
1. Take the Leader Hose (the one with the gray cuff) and attach the float halves 24 inches
(60 cm) from the gray end. OR if you have the 2 snap on floats snap them at 20 to 25
inches from the gray cuff. This is the section of hose that attaches to the TRX-20
in Step 3. (We have already done this step for you).
Gray Cu
Float 1
2 Snap On
Floats
4
Preparing your pool . . .
Connecting the hoses . . .
Float 2
POINT RETURN FITTINGS DOWN
2. Connect all the hoses (except the Leader Hose).
Connect male to female. If need be wet the hoses
for easier assembly. Now connect Leader Hose to
the end.
3. The connected hoses should be one to two
lengths longer than the furthest point from the
vacuum source (skimmer or wall fitting).
One to two
lengths over
wall fitting
or
skimmer