Hayward TRX-20 Guide D'utilisation page 29

STEP 3
Attaching the TRX-20
1. Connect the TRX-20 to the gray
cuff end on the leader hose.
2. Connect the opposite end (end of all the
hoses NOT gray) to the Adjustable
Regulator Valve. (This is needed for
skimmer applications and where there
is no 3-way valve for suction control).
See pg 6.
3. Connect the Adjustable Regulator Valve
to the Hose Cone (Valve Adapter) .
STEP 4
Getting your TRX-20 wet
AIR
With the pump turned off, lower the
TRX-20 and then vertically push
the hose down into the water until the hose is
completely filled with water.
YOU DO NOT WANT ANY AIR TO REMAIN
IN THE HOSE AND THE TRX-20
Lower the TRX-20 into the
water. While your pump is running,
take the end of the hose with the
Adjustable Regulator Valve (if you need it)
and hold it against one of the return fittings
to expunge all of the air in the hose
and the TRX-20.
OR
AIR
push
hose
down
5