Ritter ET 10 Notice D'utilisation Et De Montage page 22

The result of toasting may differ
depending on the type and
freshness of the bread.
Note:
Consuming bread that has
been toasted to an excessive
degree may be harmful to
health.
Toasting
• Place the bread in the toast-
ing slot (5).
• Push the power sliding
switch (4) downwards until it
locks into place.
• Use the buttons for setting
the toasting degree (2.4/2.5)
to select the desired degree of
browning.
Toasting then begins.
After the set toasting time has
elapsed, toasting stops.
Reheating
• Place the bread you want to
reheat in the toasting slot (5).
• Push the power sliding
switch (4) downwards until it
locks into place.
• Press the Reheat
button (2.2).
The bread takes
approx. 30 seconds to reheat.
Defrosting
• Place the bread you want to
defrost in the toasting slot (5).
• Push the power sliding
switch (4) downwards until it
locks into place.
• Press the Defrost but-
ton (2.3) and then use the
buttons for setting the toasting
degree (2.4/2.5) to select the
desired degree of browning.
The defrosting and toasting
process then begins. The bread
is first defrosted and then
toasted to the selected toasting
degree.
After the set toasting time has
elapsed, toasting stops auto-
matically.
Warming-up
Push the slide bar for the bread
and roll rack (6) to the left until
it locks into place.
The bread and roll rack is
now in the correct position.
• Place the bread you want to
warm up on the bread and roll
rack.
• Push the power sliding
switch (4) downwards until it
locks into place.
• Use the buttons for setting
the toasting degree (2.4/2.5)
to select the desired degree of
browning.
CAUTION, risk of burns:
The bread and roll rack may
become very hot. To replace
it in its slot, you should there-
fore push the slide bar to the
right until it locks into place.
Interrupting operation
• Press the Stop button (2.1)
to interrupt operation of the
appliance at any stage.
After you press the Stop button,
the toasting degree is reset to
the default settings.
WHAT TO DO IF BREAD
BECOMES JAMMED
If the item you are toasting
gets jammed in the toasting
slot, the toaster switches off
after the set toasting degree is
complete.
• You then need to unplug the
appliance from the mains.
• Carefully try to loosen the
bread and remove it from the
toaster in one piece (e.g. using
a small wooden implement).
EMPTYING THE
CRUMB TRAY
You should ideally empty the
crumb tray (9) after each use
to prevent breadcrumbs from
carbonizing or becoming baked
onto the toaster (see "Cleaning
the toaster" in the CLEANING
section).
Info:
The crumb tray can be emptied
when the toaster is upright or in
a horizontal position.
CLEANING
Clean the appliance and the
drawer after each use to pre-
vent the accumulation of food
residue.
WARNING,
risk of electric shock:
Always unplug the appliance
from the mains before
cleaning.
Cleaning the toaster
CAUTION, risk of burns:
Always allow the toaster to
cool down before cleaning.
Remove the crumb tray (9)
from the device and remove
any crumbs.
• Clean and dry the crumb
tray manually (NOT in the
dishwasher).
• Wipe down the external
housing parts with a damp
cloth.
CAUTION, risk of damage
to the appliance:
– Do not use any abrasive
cleaners, sponges with
rough surfaces or hard
brushes to clean the
appliance.
– Never clean the interior of
the toasting slot.
English
15