Pari Montesol 177 Notice D'utilisation page 37

Fill the nasal douche
The following section describes how to fill the nasal douche for
use with the PARI MONTESOL nasal rinse. If you use a differ-
ent rinse solution, fill the nasal douche as instructed in the as-
sociated instructions for use.
CAUTION
Risk of infection from contaminated water
If contaminated water is used to prepare the rinse solution,
rinsing can lead to infections of the nose.
• Always use fresh drinking water, after boiling if necessary,
to prepare the rinse solution.
• Place the nasal douche on the
valve.
• Fill the nasal douche with the
rinse solution.
Instructions regarding dosage
are included in the instructions
for use of the nasal rinse you
are using.
• Fill the nasal douche with luke-
warm drinking water up to the
bottom edge of the screw
thread.
CAUTION! Risk of injuring
the nasal mucosa if water is
too hot or too cold. The nasal mucosa can be injured by li-
quids at a temperature above 41 °C, or also by frequent
rinsing with liquids that are too cold. Therefore, use only
lukewarm water to prepare the rinse solution. If necessary,
allow the rinse solution to cool down a little or warm up to
room temperature before rinsing with it.
– 13 –