Maintenance; Scheduled Maintenance Table - KENT Razor 20 Instructions D'utilisation

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorized Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery charging
Squeegee cleaning
Brush/pad cleaning
Tank and vacuum grid with fl oat cleaning, and cover gasket
check
Squeegee blade check and replacement
Solution fi lter cleaning
Vacuum system motor fi lter cleaning
WET battery fl uid level check
Screw and nut tightening check
Brush/pad-holder motor carbon brush check or replacement
Vacuum system motor carbon brush check or replacement
Drive system motor carbon brush check or replacement (only for
RAZOR 20T)
(1) And after the fi rst 8 working hours.
(2) This maintenance procedure must be performed by a KENT authorized Service Center.
Daily, after
machine use
RAZOR 20 - RAZOR 20T
INSTRUCTIONS FOR USE
Weekly
9097063000(1)2007-06
ENGLISH
Every six
Yearly
months
(1)
(2)
(2)
(2)
15