Hitachi PC-ARFP1E Manuel D'installation Et De Fonctionnement page 23

FUNCTION SELECTION AND SETTING
4 Select "Yes" and press "OK" to start the address initialization
process.
*If the address initialization is successfully completed, connection
check will be started automatically.

Function Selection and Input/Output Initialization
This function re-establishes the function selection and Input/Output values to factory setting values.
1 Press and hold " " (menu) and " " (return) simultaneously for
at least 3 seconds during the normal mode (when unit is not
operated). The test run menu will be displayed.
2 Select "FUNC, Input/Output INITIAL" from the test run menu
pressing " " and "OK".
3 Select the indoor unit by pressing "
*This screen is not displayed when the number of indoor units
connected with the remote control switch is 1 (one). In this case,
(4) will be displayed.
4 To start initialization, select "Yes" and press "OK" on the
confirmation screen. It thakes approx. 30 seconds to complete
the process.
*Check that initialization will not cause any problems, and then
start the initialization work.
5 Select "Completed" and press "OK". The test run menu will be
displayed.
Press " " (return) on the test run menu to return to the normal
mode.
To initialize setting for the other indoor units, select "I.U. Select"
and press "OK". The screen will return to (3).
?
N O T E
• "No Function" will be indicated when the indoor unit that does not support the initialization function for "Function Selection" and "Input/Output
Setting".
• The setting for indoor units that does not support the initialization function for "Function Selection" and "Input/Output Setting" will not be initialized
even when "All" is specified at item (3).
15 PMML0404A rev.1.1 - 06/2022
" and press "OK".
02-04
FUNC, Input/Output INITIAL.
02-04
FUNC, Input/Output INITIAL.: 02-04