Measurement Operation - PCWork PCW02B Mode D'emploi

Auto Power Off
•
If there is no operation for 15 minutes , the device will turn off automatically to save
power. After an automatic shutdown, press any button to turn the device on again.
•
If you press and hold the
shutdown function will be disabled. After turning off the device, the automatic
shutdown function will be enabled again for the next measuring session. If the
screen shows the
Burnt Fuse Warning
If the symbol is displayed, the fuse is burnt out and should be replaced. Do not
continue to use the device bevor replacing the fuse!
Wrong Input Socket Warning
If the measuring probe is not inserted into the correct input socket when choosing the
current measurement function, the
measurement operation, disconnect the probes from the testing object, and insert the
probes into the correct input sockets.

Measurement Operation

Connect Measuring Probes
Do not operate the device before the test probes are not connected correctly. To
ensure this, push the cables fully into the input sockets.
button and turn on the device, the automatic
symbol, the auto power off function is enabled.
symbol is displayed. Stop immediately the
12