Assembly Instructions; Fitting The Saw Chain And Blade; Tensioning The Saw Chain - Deltafox DG-CCS 1820 T Set Traduction De La Notice D'utilisation Originale

riods of time or if the unit is not held or
maintained properly.

Assembly instructions

Turn off the appliance and, before
doing any servicing, remove the
battery.
If the tubes of the device are not
fitted into each other or screwed
correctly, the device cannot be
switched on. A safety switch pre-
vents the operation!
Use only original parts.
Assemble device
1. Interlock the end of the hex-
agonal aluminium pipe of the
telescopic arm (10) and the end
of the arm below the cutting
head (7) up to the stop. Whilst
interlocking the two, ensure that
the nose (10a) of the hexago-
nal aluminium pipe fits into the
nut (7a) at the end of the arm
(see small image).
2. Fasten both parts using the
screw sleeve (9)
Fitting the saw chain and
blade
Turn off the appliance and, before
doing any servicing, remove the
battery.
1. Loosen the mounting screw (5)
and remove the chain wheel
cover (6) (see small image).
2. Spread out the sawing chain (1)
in a loop in a way that the an-
gled cutting edges of the chain
links are aligned clockwise.
3. Place the sawing chain (1) into
the blade groove.
4. Turn the chain tensioner ring (3)
on the sprocket cover (6) in an
anticlockwise direction until the
two markings point towards
each other.
5. Place the blade (2) on the rail
bolts (27) so that the tensioning
screw (30) is pointing outward.
6. To install, hold the blade (2)
tilted at an angle of approx. 45
degrees upward, and guide the
saw chain (1) around the chain
wheel (29). It is normal for the
saw chain (1) to sag.
7. Place the sprocket cover (6) into
position. First, the lug on the
cover has to be inserted into the
notch provided on the device.
Tighten the mounting screw (5)
only by hand, as the device still
has to be tightened.

Tensioning the saw chain

Turn off the appliance and, before
doing any servicing, remove the
battery.
.
The tension of saw chain (1) is important
both for your safety and for the function of
the cordless pruner. A correctly tensioned
saw chain will increase the lifetime of your
equipment.
Check the chain tension before
each use of the cordless pruner.
• Saw chain (1) is correctly tensioned
if it can be pulled around blade 2 by
hand (wearing gloves) without sag-
ging.
• When the saw chain is tensioned with
9 N (approx. 1 kg), the gap between
GB
69