Chain Lubrication; Operation - Deltafox DG-CCS 1820 T Set Traduction De La Notice D'utilisation Originale

GB
the saw chain and the guide rail may
not be more than 2 mm.
1 Loosen the mounting screw (5).
2 Hold the tip of the blade tightly. To
tighten the saw, turn the chain tensi-
oner ring (3) in the clockwise direc-
tion. To loosen the tension, turn the
chain tensioner ring in an anticlock-
wise direction.
3 Tighten the mounting screw (5).
The chain tension in new saw
chains (1) must be readjusted after
a short operating period.

Chain lubrication

Always switch off the device and
allow the motor to cool before
filling with chain oil. There is a
risk of fire if chain oil overflows.
Blade (
( 1) must always be oiled. Non-
observance of this will result in
increased wear on the blade and
saw chain.
A full tank will last for approx.
15 minutes of continuous opera-
tion. Check the oil level in good
time.
The cordless pruner is equipped with an
oil automatic system. As soon as the mo-
tor is speeded up, the oil also flows faster
to the chain bar (
Before starting work, check the oil
level in the oil automation system (see

"Operation").

70
2) and saw chain
2).
Filling up with chain oil:
• Check the oil level indicator (22) re-
gularly and top up with oil once the
minimum mark is reached. The oil tank
holds 100 ml of oil.
• Use bio chain oil ; this product con-
tains additives that reduce wear and
tear and does not damage the pump
system. bio-oil is available from our
Service-Center.
• If you have no bio chain oil available,
use chain lubrication oil with low ad-
hesive additive content.
1. Unscrew the oil fill cap (21) and fill up
with chain oil.
2. Wipe off any spilled chain oil and
close the cap again.
Note that the saw can re-oil.
Operation
When working with the device
wear suitable clothing, work
gloves, protective headgear
and hearing protection and firm
work boots. Prior to each use it
must be ensured that the device
is operative. The on/off switch
and the safety switch must not
be locked. The motor must be
switched off when the switch
has been released. Do not use
the device if a switch is dam-
aged.
Observe noise control and local
regulations.