Assembly; Installing/Changing The Blade - Deltafox DP - CRS 2022 Traduction De La Notice D'utilisation Originale

GB
• Do not subject the battery to strong
sunlight over long periods and do
not leave it on a heater. Heat dam-
ages the battery and there is a risk of
explosion.
• Allow a hot battery to cool before
charging.
• Do not open up the battery and
avoid mechanical damage to the
battery. Risk of short circuit and
fumes may be emitted that irritate
the respiratory tract. Ensure fresh
air and seek medical assistance in the
event of discomfort.
• Do not use non-rechargeable
batteries. This could damage the
appliance.
3) RESIDUAL RISKS
Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Lung damage, if suitable respiratory
protection is not worn;
b) Cuts
c) Ear damage if working without ear
protection.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer
periods of time or if the unit is not held
or maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the
risk of serious or lethal injuries,
we recommend that persons with
26
medical implants consult their doc-
tor and the manufacturer of their
medical implant before operating
the machine.
Warning! Observe the safety
information in the operating
instructions for your DELTAFOX
20V Li-Ion series rechargeable
battery.

Assembly

Only insert the rechargeable
battery when the device is com-
pletely assembled. If the device
is switched on accidentally,
there is a danger of injury.

Installing/changing the blade

Always wear protective gloves
when handling the saw blade in
order to avoid cutting yourself.
Caution, risk of Injury!
- Do not use any blunt or bent
blades or blades which are
damaged in any other way.
- Always insert a suitable saw
blade.
Make sure that you are using the
right saw blade for the correspon-
ding material. The machine fea-
tures a coarse saw blade for wood
and two fine saw blades for metal
and plastic respectively.
Mounting the saw blade:
1. Turn the clamping lever (4) as far
to the right as possible and hold
it firmly in this position.
2. Place the saw blade into the