Water Softener Regeneration; Defects - Malfunctions - LaCimbali M21 Junior S/1 Utilisation Et Installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
This operation must be made every 250 coffees or at
least once a week.
1. Remove the water softener from the reservoir and
disconnect the tube connecting it to the machine. (Figure
1).
2. Turn the softener upside down (Figure 2) and insert the
funnel provided. Pour in 3 measures of coarse kitchen
salt (using the same measure used for the coffee).
3. Place the softener under the tap (Figure 3) and allow
hot water to pour slowly on the softener. Continue with
this procedure until the salt is dissolved and until the
water coming out of the softener is no longer salty.
4. Replace the softener into the reservoir and reconnect
the tube connecting it to the machine.
5. Before preparing other coffees, remove the lter carrier
(7) from the group, press the coffee dispensing button
(2). Wait until water is issued from the group. Then press
the Stop button (15) to stop dispensing.
Direct action by the customer
Before calling service personnel, to avoid useless expense, check whether the machine problem corresponds to one of
the cases listed below.
PROBLEM
The coffee machine is not working.
The machine does not dispense
coffee.
Indicator light (8) remains lit.
Leak from edge of lter-holder (7).
Coffee dispensing time too short.
Coffee drips out of machine.
Loss of water under the machine.
Machine cold, lamp (12) ashes.

18. Water Softener Regeneration

19. Defects - Malfunctions

CAUSE
No electricity supply.
Water reservoir empty.
Water reservoir empty.
The undercup gasket is dirty with
coffee residue.
Coffee ground too coarse.
Coffee too old.
Filter holes blocked or lter holder (7)
outlet hole dirty.
Coffee ground too ne.
Drain tray full.
Boiler not heated.
12 EN
2
SOLUTION
Check the electricity supply.
Check that the plug is inserted into
the socket and that the line separator
switch is closed
Check the position of the ON/OFF
switch (1).
Check whether the yellow indicator
(8) is lit.
Check the water level in the reservoir
(13).
Check the water level in the reservoir
(13)
Clean with the supplied brush.
Use a ner grind.
Use new coffee.
Clean.
Use a coarser grind.
Empty the drain tray.
Call technician.
1
3

Publicité

Table des Matières
loading

Table des Matières