Before You Begin; Tools And Parts Needed; Parts Included; Installation Accessories - Gaggenau VR 414 611 Notice De Montage

Before you begin

T ools and Parts Needed
B e f o r e y o u b e g i n
Screwdriver Torx T20
▯
Pencil
▯
Drill with ¼" (6 mm) bit
▯
Jigsaw
▯
Tape Measure
▯
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.

Parts Included

Installation accessories

VA 420 000 Connection strip for combination with
other Vario appliances in the 400 series
for flush installation
VA 420 010 Connection strip for combination with
other Vario appliances in the 400 series
for surface-mounted installation
VA 440 010 Stainless steel appliance cover
Use the accessories only as indicated. The manufacturer
assumes no liability for incorrect usage of the
accessories.

Cabinet Requirements

The minimum spaces that must be maintained when
installing the electric grill shall be:
A minimum 30" (762 mm)
B minimum 8" (200 mm)
C minimum 1 9 / " (40 mm)
16
D Stainless steel work surfaces: both work surfaces
must be permanently fitted on both sides of the
grill to protect the countertop when the grill is
installed separately.
When installed next to another Vario appliance, a
work surface must be fitted on the opposite side
to protect the countertop.
When installed between two other Vario
appliances, no work surface is required.
E maximum 13" (330 mm)

Countertop Requirements

9
WARNING
To reduce the risk of ignition of surrounding
combustible materials, install at least 2" (51 mm)
from both sidewalls and the rear wall.
The countertop must be level and horizontal. The stability
of the countertop must be maintained after the cut-out
has been made.
Solid surface countertops often require special
installations. For example, heat-reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to your
countertop.
en-us
Before you begin
7