Return Of Ac Power; Ups Shutdown; Using The Ups Remote Control Functions - Eaton Pulsar Série Manuel D'installation Et D'utilisation

End of battery backup time
All the LEDs go OFF.
w
The audio alarms stops.
w
The UPS is completely shut down.
3.3

Return of AC Power

Following an outage, the UPS restarts automatically when AC power returns (unless the restart function was
disabled via UPS personalization) and the load is again supplied.
3.4

UPS Shutdown

3.5

Using the UPS Remote Control Functions

EX has the choice of two remote control options.
RPO: Remote Power Off allows a remote contact to be used to disconnect all the equipment connected to
w
the UPS from the power supply. Restarting the UPS requires manual intervention.
ROO: Remote ON/OFF allows remote action of button (27). These functions are obtained by opening a
w
contact connected between the appropriate pins of connector (5) on the rear panel of the UPS (see dia-
gram on following page).
RT m odel
86-86700-00EN A02 - Page 18
Press button (27) for approximately 1 second.
The devices connected to the UPS are no longer
supplied.
Tower m odel