Generac OneWASH Mode D'emploi page 24

1. Turn the ON/OFF switch to the "ON" position
(Figure 5-2).
DELICATE
2000 PSI
Figure 5-2. ON/OFF Switch
2. Rotate pressure control knob to the position shown
on "Start" decal (Item #2) (Figure 5-3).
PRESSURE CONTROL
DELICATE
2000 PSI
Figure 5-3. Power Dial
3. Choke the engine by slowly pulling out on the choke
knob until it stops in the "ON" position (Figure 5-4).
Hearing Protection Recommended.
For a warm engine, push the choke knob down until
it stops in the "OFF" position (Figure 5-4).
20
ON/OFF SWITCH
HEAVY DUTY
3100 PSI
HEAVY DUTY
3100 PSI
NOTE:
CHOKE "ON"
CHOKE "OFF"
Figure 5-4. Choke Knob
4. Secure unit from movement when pulling recoil.
5. When starting the engine, grasp starter grip handle
(Figure 5-5) and pull slowly until you feel some resis-
tance. Then pull rapidly to start engine.
STARTER
GRIP
Figure 5-5. Starting the Engine
6. Return starter grip handle slowly. DO NOT let rope
"snap back" against holder.
7. When engine starts, slowly push the choke knob in to
the "OFF" position as engine warms. If engine falters,
pull choke knob out to the "ON" position, then push in
to the "OFF" position (Figure 5-6).
Operation
OneWASH™ Power Washer