Installing The Stainless Steel Handles; Full Overlay Panel Installation Instructions - Summit ADRD15 Mode D'emploi

Full Overlay Panel Installation Instructions (ADRD15)
This model is designed for a field-installed overlay panel,
which can cover the stainless steel to give a built-in
appearance. The overlay panel and appropriate hardware
are not included with the appliance, and you must install
the panel yourself.
Please follow the instructions below for installation:
Remove any items stored inside the drawers, and take
·
the drawers out.
Peel off the gasket, and remove the handle by
·
removing the two screws that attach the handle to the
door.
Drill the 8 holes shown by using a 9/50" drill bit on the 4
·
sides of drawer door front. (Fig.2)
Cut the overlay panels with 3/4" thickness to the
·
following dimensions: 14.88" x 14.17"(HxW).
If reusing the handles that came with the appliance, drill
·
two holes with diameter 9/50" in the overlay panel.
If user-supplied handles will be used, attach the
·
handles to the overlay panels by using the flat head
screws and drive the screws flush with the panels.
· Attach the handle and overlay panel together to the
drawer face using 2 M4x45 screws and through the 2
existing holes on the door face. Then attach the overlay
panel to the drawer face using 8 M4x45 screws and
through 8 existing holes inside the door groove. (Fig. 3)
Attach the overlay panel to the drawer face through the
·
existing holes inside the door groove, using the 8
M4x45 screws.
Peel back the gaskets, then align the left and right side
·
channels with the tracks in the cabinet. Ensuring an
even track engagement on both sides, gently push the
drawer into the cabinet until it stops.
11