Troubleshooting - Summit ADRD15 Mode D'emploi

You can solve many common problems easily, possibly saving you the cost of a service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
The appliance is not connected to
a power supply.
The
The appliance is turned off.
appliance
does not Tripped circuit breaker or blown fuse
operate.
The temperature is not set
correctly. The ambient
temperature could require a lower
The
temperature setting. The drawers
appliance
are opened too often.
is not cold
enough.
A drawer was not closed
completely. A drawer is not
hermetically sealed. The
condenser is too dirty.
The ventilation opening is blocked or
is too dusty.
The ambient room temperature
is higher than average.
A large amount of food has
The
been added to the appliance.
appliance
turns itself
The drawers are opened too
on and off
frequently.
often. A drawer is not closed
completely.
A drawer gasket does not seal properly.
The appliance is not connected to
a power supply.
The light
Tripped circuit breaker or a blown fuse
does not
work.
The light is switched off on the
control panel.
The appliance is not properly leveled.
Vibrations
The rattling noise may come from the flow of the refrigerant, which is normal. As
each cycle ends, you may hear gurgling sounds caused by the flow of
The
refrigerant in your appliance.
appliance
seems to If temperature fluctuations occur, the contraction and expansion of the inner
walls may cause popping and crackling noises.
make too
much noise. The appliance is not properly leveled.

TROUBLESHOOTING

POSSIBLE CAUSE
Connect the appliance.
Turn on the appliance.
Turn the circuit breaker on
or replace the fuse.
Check the set
temperature. Set a lower
temperature.
Do not open drawers more often
than necessary.
Close the drawer properly.
Check the seal and clean or replace.
Clean the condenser, when
necessary.
Clear any obstructions, and
wipe off the dust.
Place the appliance in a location with
a cooler ambient temperature.
Leave the appliance to work
until the set temperature has
been reached.
Do not open the drawers more
often than necessary.
Close drawer properly.
Check the drawer seal and clean
or replace it.
Connect the appliance.
Turn the circuit breaker on
or replace fuse.
Switch on the light.
Level the appliance
using the adjustable feet.
Level the appliance with
the adjustable feet.
17
REMEDY