Extension Cord; Anti-Tip Bracket Installation - Summit ADRD15 Mode D'emploi

To prevent accidental injury, the cord should be secured behind the appliance and not left exposed
or dangling.
The appliance should always be plugged into its own individual electrical outlet, which has a voltage
rating that matches the rating label on the appliance. This provides the best performance and
prevents overloading house wiring circuits, which could cause a fire hazard from overheating. Never
unplug the appliance by pulling on the power cord. Always grip the plug firmly and pull straight out
from the receptacle. Immediately repair or replace all power cords that have become frayed or
otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at
either end. When moving the appliance, be careful not to damage the power cord.

Extension Cord

Due to potential safety concerns under certain conditions, it is strongly recommended that you do
not use an extension cord with this appliance. However, if you must use an extension cord, it is
absolutely necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord
having a grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at
least 10 amperes.

Anti-Tip Bracket Installation

To reduce the risk of tipping the appliance by abnormal usage or improper loading, the appliance
must be secured by properly installing the anti-tip device packed with the appliance.
1. Place the anti-tip bracket on the floor as shown in the figure below. The anti-tip bracket must be
installed at the left side.
2. Mark the locations of the 4 holes of the anti-tip bracket on the floor.
3. Use a 11/50" masonry drill bit, and insert plastic anchors.
4. Secure the anti-tip bracket to the floor, using screws.
5. Slide appliance into position, and make sure the leg engages the anti-tip bracket.
NOTE: If the appliance is relocated, the bracket must be removed and installed in the new location.
7