Installing The Stainless Steel Handle; Operating Your Appliance; Control Panel - Summit SCR1536B Mode D'emploi

6. Relocate the door to the designated position. Then screw the bottom hinge assembly on the left
designated position and tighten it after the door is leveled. (Fig. 1)
7. Remove the handle from the left side of the door and install it on the right side. (See next section.)

INSTALLING THE STAINLESS STEEL HANDLE

This appliance includes a stainless steel handle that is not required to
operate the unit. To install the handle, follow the instructions below:
Locate the handle 1 over the pins 3 of the door and tighten the handle
by screwing the Allen key grub screws 2.
It is recommended you install the appliance in a place where the ambient temperature is between 72º and
78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions
may cause interior temperatures to fluctuate. The range of 36º-43ºF (2º-6ºC) may not be reached.

CONTROL PANEL

ON/OFF Power
To turn the appliance ON or OFF, touch the
Light
To control the function of the interior light (see INTERIOR LIGHT on page 10).
Up
To increase (warm) the set temperature by 1°C/1ºF.
Down
To decrease (cool) the set temperature by 1°C/1ºF.
ºF/ºC Selector
Select the temperature display setting in Fahrenheit or Celsius degree. To change the
temperature from Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold the
Light key for 5 seconds.

OPERATING YOUR APPLIANCE

symbol and hold for 5 seconds.
9
2 3
1