Allocate The Remote Controlled Socket A Control Button On The Remote Control; Connecting Devices - SilverCrest 101170 Instructions D'utilisation Et Consignes De Sécurité

Preparation
Remove the cover
compartment of the DIP switch
With the DIP switch
same system code as the remote
control with the number 1 to 5.
1
Allocate the remote
controlled socket a
control button on the
remote control
With the DIP switch
control button, A to D, into remote
control :
1
Note: E can not be selected with
the DIP switch.
DIP switch
remote controlled socket
A B
A ON OFF OFF OFF OFF
B OFF ON OFF OFF OFF
C OFF OFF ON OFF OFF
D OFF OFF OFF ON OFF
Put the cover
11
Put the screws
the screw holes and tighten them.
Example
Put the system code 123 into the remote
control by pushing the DIP switch
1
up to „1", „2" and „3" whist keeping
„4" and „5" in the down position:
10 GB
above the
11
10
put in the
10
put in a
10
C D E
back on.
in the threads of
12
View back side of the remote
control
.
Put the system code 123 in all of the re-
mote controlled sockets
remote controlled socket
control button „A" on the remote con-
trol by pushing the DIP switch „A"
1
up for the remote controlled socket
whilst keeping the DIP switches B, C,
and D in the down position. This remote
controlled socket
switched on and off with the control
button „A" on the remote control
View back side of the remote
controlled socket

Connecting devices

Plug the remote controlled socket
into an earthed household socket.
To guaranty the protection type IP44,
the remote controlled socket
be plugged exclusively into sockets with
protection type IP44. With use in com-
bination with a IP20 socket there is no
moisture protection guarantee.
. For the first
7
chose the
7
7
can now be
7
.
1
7
should
7