Contents; Directions For Use; Putting On The Device; Starting Each Day's Treatment - CMF OL1000 Instructions D'utilisation

EN

Contents

Directions for Use

CAUTION: Never use the device if the temperature around you is
less than 41°F or over 104°F (5°C to 40°C) or the device may not work
properly . The device should be in this temperature range for one hour
before treating .

Putting on the Device

Your doctor or service representative will:
• Show you how to place the device correctly over the spot of your
non-healing broken bone;
• Show you how to use the latch or straps to hold the device in place,
if needed; and
• Show you how to use the device .

Starting Each Day's Treatment

• Put the device on as you were shown .
• Use the device as you were shown .

Putting on the OL1000

1 . Place device (Figure 2, above) centered around where your broken
bone is located on your body . If you have a cast, brace or external
fixator, you may remove the foam pads from the OL1000 for a better
fit .
2 . Close the strap, if you use one .
6
LIQUID CRYSTAL
DISPLAY
Figure 2 . OL1000