Troubleshooting - Panasonic HL-CX667S Mode D'emploi Et Notice D'installation

Troubleshooting

Problem
The oven display
stays OFF�
Keys react even when
only their vicinity is
touched�
Cooling fan continues
to run after oven is
turned off�
Oven is not heating�
Oven is not cooking
evenly�
Oven temperature is
too hot or too cold�
Oven lamp is not
working properly�
Clock and the
reminder function are
not working properly�
Excessive moisture is
in the oven�
Enamel coating of
the oven cavity has
removed�
The oven is not turned
on�
The oven lamp is
dimming�
All manuals and user guides at all-guides.com
Possible Causes and Solution
Turn off the power, and 1 minute later, turn on the power. If the
condition persists, contact a qualified technician or an authorized
service center.
Clean the key surface and make sure the button surface is dry.
If the condition persists, contact a qualified technician or an
authorized service center.
The cooling system comes into operation as soon as a cooking
function starts. It will continue to work for 15 minutes or until
the temperature of oven becomes below 160 °F (70 °C) after
cooking is finished.
(1) When using the reminder function, oven will turn on
automatically at preset time. Press
function. (2) Check the circuit breaker or fuse box to your house.
(3) Make sure there is proper electrical power to the oven. (4)
Make sure the oven temperature has been selected. (5) Make
sure the oven function has been selected.
(1) Verify food is not in the oven during preheating. (2) Verify
the cooking mode. (3) Refer to the operating instructions for tips
on the best rack position to use. (4) Check that the appropriate
temperature is set for the recipe.
(1) Check that the appropriate temperature is set for the recipe.
(2) The heating elements are not working. If condition persists,
contact a qualified technician or an authorized service center.
Replace or reinsert the lamp bulb if loose or defective. Touching
the bulb with fingers may cause the bulb to burn out.
Make sure there is proper electrical power to the oven. See
Clock Setting (p. 9) and Reminder Function (p. 11).
When cooking is finished, open the door slowly staying from the
oven as far as possible to prevent the body from being burned
by steam.
When oven racks are removed and replaced, always tilt
them upward and do not force them to prevent the enamel
from chipping. Even if a small area of the cavity enamel
has removed, it does not affect using. However, the soonest
replacement is recommended to prevent the metal under the
enamel coating from rusting.
Check the circuit breaker and the fuse, and reset the circuit
breaker or replace the fuse if it is tripped or blown.
If the condition persists, contact a qualified technician or an
authorized service center.
(1) This may be caused by the voltage instability when the
higher power level is used for cooking. It does not indicate
a problem with your oven. (2) Wipe and clean the covering glass
of the lamp to get the maximum brightness.
twice to cancel the
EN-19