HP Photosmart C4380 All-in-One Série Guide D'utilisation page 9

To set up the HP All-in-One on an integrated
wireless WLAN 802.11 network, you need to
do the following:
First, collect all of the required materials.
Next, install the software and connect the
HP All-in-One to the wireless router.
What you need for an integrated wireless WLAN 802.11 network
To connect the HP All-in-One to an integrated wireless WLAN 802.11 network, you will
need the following:
❑ A wireless 802.11 network that includes a wireless router or access point.
❑ A desktop computer or laptop with either wireless networking support, or a network
interface card (NIC). The computer must be connected to the wireless network that
you intend to install the HP All-in-One on.
❑ If you connect the HP All-in-One on a wireless network that has Internet access, HP
recommends that you use a wireless router (access point or base station) that uses
Dynamic Host Configuration Protocol (DHCP).
❑ Network name (SSID).
❑ WEP key or WPA Passphrase (if needed).
Connect to an integrated wireless WLAN 802.11 network
The HP Photosmart Software CD and included USB setup cable provide an easy way to
connect the HP All-in-One to your wireless network.
See this section:
"What you need for an integrated wireless
WLAN 802.11 network" on page 9
"Connect to an integrated wireless WLAN
802.11 network" on page 9
Integrated wireless WLAN 802.11 network setup 9