Transport; Putting Into Operation - Binzel ABIDRIVE CW Mode D'emploi

5 Putting into operation

4.1 Transport

The scope of delivery is carefully checked and packaged, however damage may occur during shipping.
Checking procedure
on receipt of goods
In case of complaints
Packaging for return
shipment
Tab. 6
NOTICE
• The ABIDRIVE CW must be transported and operated in upright position only.
4.2 Storage
Physical storage conditions in a closed environment:
 Tab. 1 Ambient conditions on page EN-4
5 Putting into operation
Risk of injury due to unexpected start-up
An unexpected start-up of the device can result in very serious injuries.
• Prior to performing work on the system, de-energise the entire system.
• Close off the compressed air supply.
• Close off the gas supply.
NOTICE
• The system may only be put into operation by authorised personnel (in Germany see TRBS 1203).
5.1 Installation
Risk of injury due to tilting of ABIDRIVE CW
Risk of crushing of body parts due to
• When installing the ABIDRIVE CW the tilting stability is guaranteed up to an angle of 15°. Do not
• Install the ABIDRIVE CW ensuring a stable position and secure it.
EN - 8
Make sure that the shipment is complete by referring to the delivery note!
Check the delivery for damage (visual inspection)!
If the delivery has been damaged during transport, contact the last carrier
immediately! Keep the packaging for possible checks by the carrier.
Use the original packaging and the original packaging material. If you have
questions concerning the packaging and safety during shipment, please
consult your supplier, carrier or transporter.
Transport
DANGER
WARNING
exceed the angle of 15°.
TIG cold wire feeder