Earlex SprayPort HV6002 Manuel D'instructions page 3

INTRODUCTION
This powerful spray system applies coatings faster than brushing or rolling whilst maintaining a
smooth and accurate finish.
The SprayPort series is designed for the professional decorator and finisher. The latest
®
technology and materials combine to deliver a consistently high performance.
The SprayPort series is simple to set up using quick-connect fixings.
®
The spray gun delivers a high volume of air via the fluid tip for a precise finish.
The powerful steel turbine incorporates open cell air filters for a continuous and clean air flow.
Air is fed to the gun through the lightweight HyperFlex hose made from Thermo-Vulcanised
Polymer.
The HV6000 series sprays a wide range of paint with or without dilution.
To achieve the desired results only use good quality paint or coating. Keep in mind that low
temperatures make paint or coating thicker. Therefore use of the Spray Gun is not recommended
below a minimum temperature of 15°C.
TECHNICAL SPECIFICATION
Turbine
Motor type
Voltage
Frequency
Current
Air filters
Pressure rating
Air flow
Air Hose
TM
6002
2 stage
Tangential
120V
60Hz
9.6A
Dual removable filters
psi 4.5 (0.31 bar)
90 CFM (2550 l/min)
25ft (7.6m) vulcanised
polymer
3
6003
3 stage
Tangential
120V
60Hz
10A
Dual removable filters
psi 5.5 (0.38 bar)
90 CFM (2550 l/min)
25ft (7.6m) vulcanised
polymer